Opening

0. Arrive at least 30 min before your session is scheduled to begin.

1. Enter the building through the northwest set of doors. Only one of these doors accepts a key. You will be able to tell which one from the outside. Once you have unlocked the door and entered, be sure it is securely latched behind you.

2. You have 30 seconds to go to the alarm and disable it. This should be plenty of time.

3. Unlock the main doors.

4. Check the dehumidifiers and empty if necessary.

5. Turn on the parking lot, hallway, and track lights if it will be dark by the time you leave.

6. Remove the cables from the exit doors opposite the tunnel.

7. Turn on both the track lights and the perimeter lights.

8. If it is below 12-degrees inside, turn on the furnace (low setting) and the circulating pump (the circulating pump is on when the switch is pointing up). Do not turn on the heater fans until the furnace temperature rises above 120.

9. Go up into the gondola, turn on the ceiling fans, and plug in the floodlights.

10. On your way down to the track, turn on the sign above the tunnel.

11. Cross the track and turn on the sign above the opposite tunnel. Also turn on the visitor side floodlights.

0. Inspect the track for damage and repair if necessary (see track repair).

1. Turn on the computer, start Orbits, and start your session (see equipment\using Orbits).

2. If you turned on the furnace and the circulating pump at step 6, turn on the fans.

UP

NEXT