|
Clock Setup and Programming Setup: Connect the phone cable to the RX jack on the clock (bottom left looking from the back) and the TX jack on the timer (leftmost looking from the back). Connect the AC adapter cord to either the timer or the clock and plug it in. Setting the time of day: Press and hold down the “Clock” button. Press the Min/Sec button. Turn the dial to select the hour (24 hour clock). Press the Min/Sec button again. Turn the dial to select the minute Press the clock button twice (ignore seconds). Changing the time display: Press the “Clock” button (do not hold it down). The display time will switch from 24-hour clock to 12 hour clock to min/sec. display (only on the timer), and back to 24-hour clock with repeated presses of the button. Turning on/off the Beep: Press and hold down the Mode button. Turn the dial to “60” to turn the beep off. Turn it to any other number to turn it on. Press the Mode button again. Setting the clock to count time up
from 00.00: Hit preset #1 (blue button). 00.00 should show, the Beep light should be off, and the “Up” light should glow. If all these things don’t happen, someone has altered the preset and you will have to follow the instructions below. If they do, just hit “Start/Stop” to begin the timing. Hit “Start/Stop” again to stop timing. Hit “Reset” to set the timer back to 00.00 Note: the clock lags almost a second behind the timer! Setting the clock to count time up
from 00.00 (alternate method): Turn off the beep (see instructions above) Hit the “Beep Up/Dn” button until the “Up” light glows. Hit the “Reset” button. If the display does not show “00.00” turn the dial to adjust. Hitting the “Min/Sec’ button will give you the option to adjust the hours, minutes, and seconds with the dial. Once the display is set to 00.00 hitting “Start/Stop” will begin the timing. Hit “Start/Stop” again to stop timing. Hit “Reset” to set the timer back to 00.00 Setting the clock to count time down: Turn on the beep (see instructions above) if you want to hear a beep at the end of timing. Note that the clock will keep beeping until someone presses the reset button unless you adjust the beep mode (see below). Hit the “Beep Up/Dn” button until the “Up” light turns off. Hit the “Reset” button. If the display does not show the time you want to count down from turn the dial to adjust. Hitting the “Min/Sec’ button will give you the option to adjust the hours, minutes, and seconds with the dial. Once the display is set to the time you want hitting “Start/Stop” will begin the countdown. Hitting “Start/Stop” again will interrupt the countdown and hitting it again will resume it. Hit “Reset” to set the timer back to the beginning. Adjusting the beep mode: Press down and hold the “Start/Stop” button. Turn the dial to select from the following options: -0 : at the end of the count, the beep will keep sounding until someone hits the reset button -1: at the end of the count, the beep will sound once and the “done” light will flash until someone hits the reset button -2: at the end of the count the beep will sound once and the clock will reset and start counting down again -3: at the end of the count the beep will sound once and the clock will start counting up from 00.00 (if counting down) or keep on running (if counting up) Blue Preset Buttons: Holding down a preset button will store the current settings in memory so that when the button is pressed again that program will be loaded. I have set the following programs: 1 – count up from 00.00. No beep 2 – count down from 00.16, beep once, go back to 00.16 and repeat (beep every lap) 3 – count down from 10.00, beep once, go back to 10.00 and repeat (for sprints every 10 min.) |