|
Set Up 1. Plug in the compressor and turn it on. 2. Turn on the countdown timer Flip the switch up to “Program.” The numbers should start to flip. Use the start and set buttons to change the numbers until 12 seconds is showing. One button will advance the numbers, the other will cycle between first number, second number, and both. Advance the numbers when just one is flipping. When you see 12, get both numbers to flip and move the switch back down to “Run.” 3. Turn on the handheld com. Set the com to 12 seconds. Hit the plus or minus buttons to set the tens of seconds, then the red button to switch to single seconds, then the red button again to set. After a few seconds the com will be ready to work. 4. Load the start gate with compressed air by attaching the hose from the compressor to the nipple. Do not load too soon. The air leaks out slowly. Open the control panel and turn on the off/on switch. (Press down the “|” side of the button.) Set the start gate up on the track, being sure the lower legs are positioned in the cups drawn on the track surface. |